Shopping Cart
Your shopping cart is empty!

ECET 365 Week 1 Homework Problems 8.9, 8.10, D8.13, D8.14, D8.15 NEW

ECET 365 Week 1 Homework Problems 8.9, 8.10, D8.13, D8.14, D8.15 NEW
Model:Latest
Price: $10.00 $8.00
Qty:   Check out
This Tutorial Purchased: 7  Times.  Tutorial Rating: A+

attachments This Tutorial contains following Attachments:

  • ECET 365 Week 1 Homework 8.9, 8.10, D8.13, D8.14, D8.15.docx

ECET 365 Week 1 Homework Problems 8.9, 8.10, D8.13, D8.14, D8.15 NEW

Page 454-455 

Problems 8.9, 8.10, D8.13, D8.14, D8.15

8.9) A stepper motor has 24 north teeth and 24 south teeth. What angle change occurs on each step?

If a full step is output every 1 ms (and assuming it doesn’t slip), at what speed does the motor spin?

8.10) Draw a figure similar to figure 8.80 showing how half stepping works.

D8.13) Design an interface for a +24 V, 500 mA geared DC motor. The time constant of the motor is

D8.14) Design an interface for a +12 V, 500 mA bipolar stepper motor. There are 200 steps/revolution.Write the software to spin the motor at 1 rps.

D8.15 An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs at least 100 mA. Limit the coil voltage to 6 V. Write three software functions: Alarm_Init, Alarm_On, and Alarm_Off.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

A   B   C   D   F  

Enter the code in the box below:



Assignment Cloud © 2019 All Rights Reserved